Checklist · Plant & Equipment Inspections

Elevated Work Platform (EWP) Inspection Checklist

Pre-use and periodic inspection checklist for Elevated Work Platforms including scissor lifts, boom lifts and vertical mast platforms. To be completed before each use and at regular intervals per the manufacturer's maintenance schedule.

32 checklist items · Last reviewed

Checklist Items

ItemPass / YesFail / No
Date
EWP Type (scissor / boom / vertical mast)
EWP Asset Number / Serial Number
Operator Name
Hour Meter Reading
DOCUMENTATION
Plant registration current (if required)PassFail
Operator manual present in EWPPassFail
Maximum working load (MWL) placard visiblePassFail
POWER & FLUIDS
Battery charge adequate (electric) or fuel level adequate (diesel)PassFail
Hydraulic oil level adequate — no leaksPassFail
Engine oil level adequate (diesel units)PassFail
TYRES & WHEELS
Tyres in good condition — no damage or flat spotsPassFail
Wheel nuts tight and all presentPassFail
STRUCTURE
Platform, rails and safety chains — no cracks, dents or damagePassFail
Scissor arms or boom — no visible cracks or damagePassFail
Outriggers / stabilisers — extend and retract correctly (where fitted)PassFail
All fasteners, pins and retaining devices present and securePassFail
CONTROLS
Ground controls operational and clearly labelledPassFail
Platform controls operationalPassFail
Emergency lowering system operationalPassFail
Enable switch / dead-man control functionalPassFail
SAFETY SYSTEMS
Platform entry gate/chain closes and latches securelyPassFail
Emergency stop buttons operational (platform and ground)PassFail
Tilt/slope sensor alarm activates when on inclinePassFail
Horn/warning device operationalPassFail
Work lights operational (if fitted)PassFail
Fall arrest anchor points present and rated on platformPassFail
GENERAL
EWP clean and free of debrisPassFail
No damage to control cables or hydraulic hosesPassFail
Defects noted (describe)
Safe to operate?YesNo
Operator Signature